How to set in program to increase MCU stability in/out GREEN MODE?
In order to increase the stability of MCU in/out GREEN MODE, in mode switc...
- 首頁 /
- 查詢結果
查詢結果
keyword：*
-
-
Why chips can not enter sleep mode?
The program can enter Sleep Mode by setting: B0BSET CPUM0, If the system ca...
-
How to set to enter low-speed mode properly?
Switching into low-speed mode can be divided into two situations: keep on e...
-
How to set before entering power down mode for low power consumption?
Before entering Power down mode, you need to make some settings as follows:...
-
In power down mode, how to set input pin to get the lowest current?
1. In sleep mode, the input pin should be set to input pull-up state and c...
-
Can target board provide system clock?
No, it can't, internal crystal oscillator of emulator is the default crysta...
-
What is the internal ILRC frequency?
Operating voltage influence internal oscillator frequency ILRC greatly, whe...
-
When you want a higher rate of program frequency(Fcpu to 16M or 8M) and real system would work in complex situations more serious flood and disturbance, whether enable Noise_Filter will give a great i
When users system works in high noise environment, it is suggested to open ...
-
What is the meaning for "1T" mentioned in SONIX MCU specifications?
The meaning of "1T" is MCU maximum operation clock speed, that is Fcpu = Fo...
-
What is the state for Xout pin in the external RC oscillator mode?
In external RC mode, the oscillation signal is input to MCU internal throu...