How to use Watchdog properly?
SONIX micro-controller watchdog timer's clock source is from internal low-s...
- Home(En) /
- 查詢結果
keyword：*
-
-
Why read T1C values wrong when using SN8P2308 RFC function?
TC1 is a 16bit counter, when reading T1C value, user must read T1CH first, ...
-
How to select parameters to get 4MHz RC oscillator frequency at VDD = 5V power supply?
When use external RC oscillator circuit to obtain system clock, It is sugg...
-
What is the meaning for "1T" mentioned in SONIX MCU specifications?
The meaning of "1T" is MCU maximum operation clock speed, that is Fcpu = Fo...
-
What is the state for Xout pin in the external RC oscillator mode?
In external RC mode, the oscillation signal is input to MCU internal throu...
-
In power down mode, how to set input pin to get the lowest current?
1. In sleep mode, the input pin should be set to input pull-up state and c...
-
How to set in program to increase MCU stability in/out GREEN MODE?
In order to increase the stability of MCU in/out GREEN MODE, in mode switc...
-
How to set to enter low-speed mode properly?
Switching into low-speed mode can be divided into two situations: keep on e...
-
For 2 series MCU, will TC0 continue to count and wake up the system under Green Mode?
For most MCU, when the system enters green mode, the wake-up source can be ...
-
Can SN8P2522 touch key wake up sleep mode?
No, it is by detecting capacitance changes to ground to determine whether k...