Why program can run into external INT0 interrupt program while FP00IEN has already been cleared?
SONIX 8-bit MCU interrupt is that once received P0.0 interrupt condition, i...
- Home(En) /
- 查詢結果
keyword：*
-
-
How to connect single key and MCU to prevent I/O port damage effectively?
In product development, the key is the most common functions, taking such c...
-
Connect pull-down resistors to I/O port, why can not read low level when there is no external signal?
SONIX MCU general I/O port built-in pull-up resistors, the equivalent resis...
-
Using Reset pin as input port (via ground key), why can not read low level?
1.Check Reset_Pin in Code Option if it is chosen right;2.For OTP MCU, this ...
-
P00 settings completely correct, why can not enter interrupt?
First, make sure P00 interrupt settings are correct, such as P00IEN is set ...
-
Why chips can not enter interrupt?
First, check the corresponding interrupt source control bit whether set to ...
-
Does SONIX MCU have interrupt priorities? How to set?
SONIX MCU hardware does not have interrupt priorities. However, in applicat...
-
How to select in Code Option when using 1M crystal?
When the selected external oscillator frequency is less than 1MHz, the choi...
-
How to select in Code Option when using 1M crystal?
When the selected external oscillator frequency is less than 1MHz, the choi...
-
How to set I/O port to save power?
Correct I/O port settings can avoid I/O extra current leakage: 1.For idle ...