Program can not enter interrupt routine, what aspects need to check?
Users need to check the following aspects: 1. Check whether the globa...
- Home(En) /
- 查詢結果
keyword：*
-
-
Can "Call" instruction be executed in Interrupt Service Routine?
Because of sonix MCU Stack number limitations, users should pay special att...
-
P00 settings completely correct, why can not enter interrupt?
First, make sure P00 interrupt settings are correct, such as P00IEN is set ...
-
Does SONIX MCU have interrupt priorities? How to set?
SONIX MCU hardware does not have interrupt priorities. However, in applicat...
-
How to set RTC when IC simulation and application, what should be note for?
1．For MCU type with RTC function(2501B, 2308, 2808, 26Lxx), in simulation, ...
-
What matters need to be paid attention to when using Sonix in-built real-time clock (RTC) function?
1 User can enable or disable RTC function by execute B0BSET FT0TB or B0BCLR...
-
Why com and seg control point can not display correctly when using LCD module?
Customer need to consider the two aspects: hardware and software. 1 Ha...
-
For 2 series MCU, will TC0 continue to count and wake up the system from Green Mode?
For most MCU, when the system goes into green mode, the wake-up source can ...
-
How to connect VLCD pin when simulate LCD function?
In the current Sonix 8-bit 2 series products, SN8P2308 and SN8P2808 have LC...
-
Can "Call" instruction be executed in Interrupt Service Routine?
Because of sonix MCU Stack number limitations, users should pay special att...